-
-
Take the 370mm (medium ones) smooth rods and 3x LM8UU bearing
-
Put the bearings on smooth rods
-
-
-
Take the x-end-idler, x-end-motor and 4x LM8UU bearing
-
Insert the bearings to plastic parts (2 in each part)
-
The bearings can be inserted only from the top (there is a rim on bottom)
-
-
-
Insert the prepared before linear shafts into plastic parts as shown on photos
-
Make sure that you put the linear shaft with two bearings on top
-
-
-
GT2-16 idler pulley, bore 3mm
-
M3 self-locking nut
-
M3x15 screw
-
Insert the screw as shown on image, guide thru idler pulley and lock using nut.
-
Do not overtighten as you can easily damage the plastic part
-
To help guiding the screw thru idler you can hold the idler by pliers
-
-
-
Mount the x-carriage on bearings as shown on image
-
Make sure the correct orientation of X-axis
-
Tighten the zipties and then cut the leftovers
-
-
-
1x 17HS4401 stepper motor, 3x M3x18 screw
-
Take the 17HS4401 stepper motor and mount it to the x-end-motor with screws
-
-
-
Take the GT2-16 pulley and mount it on the motor shaft
-
Make sure that one of the screws in pulley are touching the flat side of motor shaft
-
-
-
Take the spiral wrap and bend it over the cables from X axis, starting as shown on image
-
-
-
The X-axis is ready, you can now go to Z-axis assembly!
-
If your already finished your beverage, go to fridge for another one
-
