-
-
Take the Reprap Discount Smart controller and remove the black knob (if its supplied with)
-
Remove foil from the screen (not really necessary, if you really want - you can leave it)
-
You can also remove the paper from buzzer, but as its very loud - I recommend to leave it to make the "biips" from printer quieter
-
-
-
Take the lcd support with the additional plate and slide it over sd card reader, be careful and do not destroy the potentiometer under it
-
Take the second lcd support and slide it onto LCD, as shown on images
-
-
-
Insert the LCD with supports into lcd-cover as shown on images
-
Screw the LCD to the lcd-cover using two M3x10 screws
-
-
-
Insert the assembled LCD into front of the printer as shown on images
-
Tighten the LCD using zipties
-
Almost done!
Finish Line