-
-
Take 6 sets of pillar, screw and washer from the set with MK42 clone heatbed
-
-
-
Insert the screw from the top, and tighten it against the washer and pillar as shown on images
-
Repeat the step for all the holes marked on photo
-
-
-
Take the bigger part of heatbed-cable-cover and put on heatbed as shown on image
-
Insert 3x M3 nut into the plastic part
-
-
-
Use M3x8 screw
-
Take the spiral wrap and guide it as shown on image
-
Use 2x M3x10 screws with the second side of heatbed-cable-cover plastic
-
Remove the connector from end of the cables
-
Guide the cables like shown on the pictures
-
Almost done!
Finish Line